A video introduction and a bit more information
Bub - a video introduction
A bit more information on what I'm planning ... note: this may change
- in no specific order
- large tyres to increase ground clearance
- adjust the wings to cope with the wider, bigger tyres
- lift the rear suspension by a huge amount to make the car run level
- cut the back off, Baja style to improve entry/exit angles
- possibly trim the front as well
- fit a roll cage
- fit a bigger engine
- Before that
- strip back bubbling paint and rust treat
- repaint rusty areas with silver smoothrite (I am not changing how it looks)
- dismantle all suspension, running gear, brakes etc and
- replace if necessary
- strip clean and paint
- replace all rubber bushes, pipes, hoses
- swap the front of the chassis to carry a 'beam' front axle to remove the entire front and
- fit a 'full tilt front'
- beer keg fuel tank (from a previous buggy)
- make it look mental
- fit a 2027cc long stroke engine making 3 times as much power and torque as standard on a camper van gearbox
- fit an 1800cc engine on a standard gearbox
- fit a supercharger
- steal an old Porsche turbo engine and fit that
Comments
Post a Comment